System information

2/14/2007 VoIP Phone Administration Guide MAG-07005-2 Rev. B
18
3.5.2 WAN Settings
In this page, you can configure the IP Phone’s WAN port setting. The WAN port is for you to connect to the ADSL
Router, or Broadband Router. Also, you can use PPPoE to get the WAN IP address from your ISP.
The default setting is Bridge mode. If you don’t need to use the Bridge mode, you can change to NAT mode.
The WAN port default is DHCP Client mode. You can change the setting to Fixed IP mode, or PPPoE mode.
If you change the WAN port’s setting to Fix IP mode, then you have to make sure the IP address. Net Mask,
Gateway, and DNS setting is suitable in your current network environment.
If you change the WAN port’s setting to PPPoE mode, you have to input a correct username/password to get the
IP address from your Internet Service Provider.
When you finished the settings, click Submit. Go to the Save changes page and click Save to reflect the
changes.
3.5.3 LAN Settings
In this page, you can configure the IP Phone LAN port’s setting.