System information

2/14/2007 VoIP Phone Administration Guide MAG-07005-2 Rev. B
9
3 Setup the VoIP Phone by Web Browser
Default the IP Phone’s Bridge is enabled, WAN port is in DHCP Client Mode. LAN port is the same as WAN.
Connect the IP Phone to DHCP server, and the server assign an IP address to the phone. Check the IP address
and add the port number “:9999” at the end of the IP address to access the web browser.
Note: If the IP Phone fail to connect to a DHCP server and cannot get the IP address, you can go to Network ->
LAN Setup, and change to NAT. Then, connect LAN port to your PC, and you can use the default IP
address http://192.168.123.1:9999
to access the Web interface.
3.1 Login
Please input the username and password into the blank field. The default setting is:
1. For Administrator, the username is: root; and the password is: test. If you use the account login, you can
configure all the setting.
2. For normal user, the username is: user; and the password is: test. If you use the account login, but you can
not configure the SIP setting.
Click Login to move into the VOIP PHONE web based management information page.
Any changes in the Web Management interface except for Phone Book require clicking Submit in that page, and
then go to the Save changes page and click Save. The system will restart, and all the settings can work properly.
3.2 System Information for the IP PHONE
When you login the web page, you can see the current system information of the IP phone like Model Name,
Firmware Version, Vendor ID and Codec Version in this page.
Also you can see the function lists in the left side. You can use mouse to click the function you want to set up.