User's Guide

SETTING UP THE COMMUNICATOR
4
Care@Home™ Communicator 2.0 User Guide
2. Setting Up the Communicator
To set up the Communicator:
 Determine the best location
 Prepare the required equipment
 Install the Communicator
 Test the installation
2.1. Determining the Best Location
The desk model can be installed on a table or on a wall. The wall model can be installed only on a wall.
Choose a location that is:
 Up to 700 m (2,297 ft.) – open air from the control panel
 In a bathroom, living room or bedroom
 If mounting on a wall
 At a height of 1.4 to 1.5 m (4.6 to 4.9 ft.)
 On a clean, dry and smooth surface
2.2. Preparing the Required Equipment
Prepare the following:
 Six new 1.5V AA alkaline or lithium batteries – not included
For recommended battery manufacturers and models, refer to 5 Specifications on page 13
 Small Phillips screwdriver
 Two K2.2X8 screws - included