User's Guide

SETTING UP THE MDSENSE
Care@Home™ MDsense User Guide
9
a. Press the control panel's PAIRING button twice. The control panel responds, “Control panel
entered test mode”. The control panel’s power, communication, and trouble LEDs flash.
b. Move close to where you want to install the MDsense.
c. Remove the socket cover. The MDsense’s LED lights. The control panel responds with a voice
message.
d. Replace the socket cover or insert the pull cord or power cable.
9. To install the MDsense with screws, refer to Appendix A Installing with Screws on page 19.
10. Peel off the short protective strip from the mounting tape.
PAIRING button