User's Guide

SETTING UP THE MDSENSE
8
Care@Home™ MDsense User Guide
WARNING! A new battery can cause damage if it is incorrectly installed.
5. On the control panel, press the PAIRING button for five seconds. The control panel beeps and the
ring around the EMERGENCY button lights blue.
6. Slide the battery compartment upward into the MDsense until it clicks. The LED flashes.
7. Ensure that the pairing process is successful. The process can have the following results:
 Success The control panel beeps and the control panel ring blinks blue three
times.
 Failure The control panel beeps and the control panel ring lights up red for
two seconds. Try to pair again.
 Already paired The control panel beeps, the control panel ring lights up blue, and the
EMERGENCY button lights up red.
8. Test communication with the control panel:
PAIRING button