User's Guide

MAINTAINING THE MDSENSE
14
Care@Home™ MDsense User Guide
3. Insert four 1.5 V C alkaline batteries into the battery compartment, for each battery:
a. Place the negative (-) end of the battery against the spring.
b. Press the positive (+) end of the battery toward the battery compartment until it clicks.
WARNING! New batteries can cause damage if incorrectly installed. Replace the
batteries only with recommended models. Refer to 5. Specifications on page 14.
4. Slide the battery compartment upward into the MDsense until it clicks. The LED flashes.
4.2. Updating Software
To perform software and firmware updates for the MDsense, use the remote boot function in
Care@Home™ CMS. Refer to ESUG05074 Care@Home CMS Reference Manual.