User's Guide
Table Of Contents
- 1. Overview
- 2. Installing the C7000
- 3. Operating the C7000
- 4. Restoring Factory Settings
- 5. Removing All Peripherals
- 6. Maintaining the C7000
- 7. Specifications
- Appendix A Testing Peripherals
TESTING PERIPHERALS
26
Care@Home™ C7000 User Guide
4. Remove the MDsense’s battery compartment, by pressing the release buttons and pulling
downward. The MDsense goes into test mode for 10 minutes.
5. Slide the battery compartment upward into the MDsense until it clicks. The LED flashes.
6. Walk in front of the MDsense. The LED flashes.
7. Lie on the floor. Remain still while the LED is solid red. Remain on the floor until the LED flashes
slowly.
8. Press the control panel’s RESET button. The control panel exits test mode.