User's Guide

Setting Up the MDsense
10
Care@Home™ MDsense User Guide
b. Move close to where you want to install the MDsense.
c. Remove the socket cover. The MDsense’s LED lights. The control panel responds with a voice
message.
d. Replace the socket cover or insert the pull cord or power cable.
9. To install the MDsense with screws, refer to Appendix A Installing with Screws on page 18.
10. Peel off the short protective strip from the mounting tape.
11. Place the back of the MDsense against the wall so that the protective strip touches the wall.