User Guide Part 7

Installation of the We.R™ System
174
We.R
™
System User Guide
Figure 141: Universal Transmitter Base with Screws
3. Place and hold the base on the desired mounting location and mark the drilling locations
(the above-mentioned punch-outs 1 and 2).
4. Drill the holes; insert two (2) dowels if needed, place the base over them and screw in the
two (2) screws.
3.13.2.3. Installing with Pre-attached Double-side Tape
The pre-attached double-sided tape will be mostly used in installations of the Universal
Transmitter.
1. Release the base (see Figure 140 above).
2. Peel the tapes’ protective covers.
3. Attach the base to its designated location while applying slight pressure.
4. Attach the Universal Transmitter body back into the base.
3.13.2.4. Dismounting the Universal Transmitter
For dismounting the Universal Transmitter (i.e. in case of battery replacement):
2
1