User Guide Part 7

Installation of the We.R™ System
We.R
™
System User Guide
185
The CCU should be back in full-operational mode (front panel LED turns green) within about 30
seconds. This could be verified as described in paragraph 3.14.3.1 below.
Note: The We.R
™
Z-Wave
®
Controller is powered by the We.R
™
Central
Control Unit’s power adaptor only and will not be powered by the We.R
™
CCU’s backup battery In case of mains power failure.
3.14.3.1. Verification
Verification of Central Control Unit returned into its fully-operational mode is required following
the installation procedure as well as the addition of the We.R
™
Z-Wave
®
Controller reported by
the system.
The verification is done by activating the We.R
™
Web Application software (described above in
paragraph 3.3. The We.R
™
Web Application) and checking for the We.R
™
Z-Wave
®
Controller
status row in the Dashboard page (see Figure 28 on page 56).
3.14.4. Activating the Z-Wave
®
Controller
Once the Z-Wave
®
Controller is installed, it is time to add the definitions of the Z-Wave
®
remotely controlled devices to configure the system to work with them properly.
The next paragraphs detail how to:
 Add new Z-Wave
®
remotely controlled devices.
 Remove previously added Z-Wave
®
remotely controlled devices.
 Control Z-Wave
®
remotely controlled devices via the We.R
™
system.
3.14.4.1. Adding a New Z-Wave
®
Device
Prior to the process of adding a new Z-Wave
®
remotely controlled device, you need to get
familiar with the additional Smart Home page in the We.R
™
Web Application Data Window.