User Guide Part 5
Installation of the We.R™ System
We.R
™
System User Guide
151
3. Attach the base to its designated location while applying slight pressure.
4. Attach the Transmitter Unit back to its base.
3.11.2.5. Installing Sensor Unit with Pre-attached Double-side Tape
Pre-attached double-sided tape will be mostly utilized for the installation of the Sensor Unit.
1. Peel the tapes’ protective covers.
2. Attach the base to its designated location while applying slight pressure.
3.11.2.6. Dismounting the Flood Detector
For dismounting the Flood Detector (Transmitter unit only) from its designated installation site
(i.e. in case of battery replacement):
1. Insert a coin (or flat screw driver) into one of the edge slots as demonstrated in Figure 120
below.
2. Twist it to raise the cover (body) edge.
3. Pull the body strait out of the base’s shoulders.
Figure 120: Dismounting the Flood Detector Transmitter Unit