User Guide Part 5

Installation of the We.R™ System
150
We.R
System User Guide
3. Place and hold the base on the desired mounting location and mark the drilling locations
(the above-mentioned punch-outs 1 and 2).
4. Drill the holes; insert two (2) dowels if needed, place the base over them and screw in the
two (2) screws.
5. Attach the Transmitter Unit onto its base.
3.11.2.3. Installing the Flood Detector Sensor Unit with Screws
1. Place and hold the Sensor Unit base on the desired mounting location and mark the drilling
locations.
2. Drill the holes; insert two (2) dowels if needed, place the Sensor Unit base over them and
screw in the two (2) screws.
Figure 119: Mounting the Sensor Unit with Screws
3.11.2.4. Installing Transmitter Unit with Pre-attached Double-side Tape
The pre-attached double-sided tape will be mostly utilized for installation of the Transmitter
Unit.
1. Release the Transmitter Unit base (see above Figure 117).
2. Peel the tapes’ protective covers.