User Guide Part 3

Installation of the We.R™ System
86
We.R
System User Guide
Note: In case the installation of the battery could not be completed within
the three (3) minutes period, it is possible to restart the process by applying
steps 3 (page 84) and onwards again.
14. Insert the battery into the Key Fob’s cavity with its pole facing out/up as demonstrated in
Figure 57 below.
Figure 57: Inserting the Remote Control Unit’s Battery
18. Seal the cover by turning it a quarter of a circle (90
o
) clockwise.
19. A built-in software will:
i. Trigger a self-test program which will cause the Remote Control Unit’s entire front
panel LEDs to blink twice to indicate that the battery was properly installed.
ii. Triggers an automatic software handshake procedure in which the KF communicates
with the Central Control Unit to flag its presence.
20. Other ways to verify that the Remote Control Unit (KF) was properly added to the system
are:
i. By pressing the Status key to see the right status LED turning ON (see sub-
paragraph 3.5.3 below), or,