User Guide Part 3

Installation of the We.R™ System
We.R
™
System User Guide
121
In such a case, it is possible to re-initiate the Add New Device process by clicking over the
button.
Clicking over the button will terminate the Add New Device process.
11. If the new Magnetic Sensor was properly detected by the CCU within this time-frame, the
counter will freeze and a Device Properties sub-window will appear within the Add New
Device window, where the Magnetic Sensor’s system name/location needs to be typed-in.
Figure 89: Add New Magnetic Sensor Device Properties
Clicking over the button will end the Add New Device process while the new
Magnetic Sensor is added onto the system configuration.
12. Clicking over the button will enlarge this sub-window for further possible
definitions of the Magnetic Sensor’s operation modes.