User Guide Part 3

Installation of the We.R™ System
We.R
™
System User Guide
117
2. No need to release the base of the Magnet unit.
3. Peel the tapes’ protective covers of both units.
4. Attach the base of each unit to its designated location while applying slight pressure.
5. Attach the Transmitter back into the base.
3.8.2.4. Dismounting the Magnetic Sensor
For dismounting the Magnetic Sensor (Transmitter unit only) from the door/window (i.e. in case
of battery replacement):
1. Insert a flat screw driver (or coin) into one of the edge slots as demonstrated in Figure 84
below.
2. Twist it to raise the cover (body) edge.
3. Pull the body strait out of the base’s shoulders.
Figure 84: Dismounting the Magnetic Sensor’s Transmitter