User Guide Part 3

Installation of the We.R™ System
116
We.R
™
System User Guide
3.8.2.2. Installing the Transmitter Unit with Screws
1. Release the Transmitter unit’s base by inserting a coin into one of the edge slots, as
demonstrated in the above Figure 80, and twist it to open the cover.
2. Use a flat screwdriver to remove the punch-outs 1 and 2 (see Figure 83 below).
Figure 83: Magnetic Sensor Transmitter Unit Base with Screws
3. Place and hold the base on the desired mounting location on the window/door frame and
mark the drilling locations (the above-mentioned punch-outs 1 and 2).
4. Drill the holes; insert two (2) dowels if needed, place the base over them and screw in the
two (2) screws.
5. Attach the Transmitter Unit back to its base.
3.8.2.3. Installing with Pre-attached Double-side Tape
Due to the common installation (door/window) of the Magnetic Sensor, the pre-attached
double-sided tape will be mostly used for both the Transmitter and the Magnet units.
1. For the Transmitter unit – release the base (see above Figure 80).
2
1