User Guide Part 3
Installation of the We.R™ System
We.R
™
System User Guide
115
The Magnetic Sensor must be mounted within 700m (2300ft) (open air nominal) of the
CCU.
Typically, the Transmitter unit will be attached onto the fixed frame of the window/door
while the Magnet unit – to the moving edge.
Figure 81: Typical Location for Magnetic Sensor Installation
Special attention should be given, throughout the installation process of the Magnetic
Sensor, to the final arrangement of the two units – they should end up aligned to each
other (dot-to-dot) as demonstrated in Figure 82 below, as well as mounted with 1-2mm
(0.04-0.08 in.) gap between them when door/window is closed.
Figure 82: Dot Alignment of the Magnetic Sensor Units