User Guide Part 3

Installation of the We.R™ System
112
We.R
™
System User Guide
This test runs for about 10-minutes and during this period the device sends an event to the
Central Control Unit following detecting an actual event.
3.7.4.2. The Normal Operation Mode
Following the termination of the Walk Test Mode (i.e. after 10 minutes), the system switches
the Motion Detector into Normal Operation Mode. This mode saves Motion Detector battery
power.
In this mode, the Motion Detector switches into 2½ minutes hibernation period following a
detection event. This means that the Motion Detector will not transmit events to the Central
Control Unit during this period.
If a detection event occurs during this hibernation, the timer counting the 2½ minutes will
restart counting the 2½ minutes.
This process will repeat itself until there is no detection for the entire 2½ minutes.
Following the 2½ minutes hibernation period, the Motion Detector will be switched back to
normal triggering mode of operation.
Note: Advanced Configuration of the Motion Detector can be found in
paragraph 4.5.4 below.
3.8. The Door/Window Magnetic Sensor (MGL) – ES800MGL
The Magnetic Sensor (MGL) is a We.R
™
Door/Window Magnetic Sensor/Detector.
This sensor device consists of two (2) parts – a smaller passive magnet unit (the Magnet) and a
larger magnetic detector with a RF transmitter unit (the Transmitter).
Accessories available for the Magnetic Sensor:
 Double-sided adhesive tape on both the Transmitter and the Magnet.