User Guide Part 3

Installation of the We.R™ System
We.R
System User Guide
111
In the case of a Motion Detector these definitions include:
Motion Detector arming scenarios
Armed Motion Detector response
Unarmed Motion Detector response
These details may be added or edited later, by a Master User, from within the We.R
Web
Application’s Devices page.
Clicking over the button will end the Add New Device process while the new
Motion Detector is added onto the system configuration with more detailed definitions.
16. You may verify that the Motion Detector (PIR) was properly added by checking the details
of the We.R
Web Application’s Devices page.
Note: Advanced Configuration of the Motion Detector can be found in
paragraph 4.5.4 below.
3.7.4. The Motion Detector Operational Modes
The We.R
system has two operation modes for the Motion Detector devices:
Walk Test Mode
Normal Operation Mode
3.7.4.1. The Walk Test Mode
The Walk Test Mode is a test mode used following a device power-up (replacement of a
battery or after adding the Motion Detector as a new system device) for initial testing of the
system functionality.