User Guide Part 3

Installation of the We.R™ System
We.R
™
System User Guide
109
Note: In case the installation of the batteries could not be accomplished
within the three (3) minutes period, it is possible to restart the process by
applying step 1 (on page 107) and onwards again.
9. The insertion of batteries into the Motion Detector triggers a handshake process in which
the Motion Detector communicates with the CCU to inform it of its presence and the CCU
add it to its peripherals’ inventory.
10. If the CCU did not detect the new Motion Detector within this time-frame, the following
error ( ) message will appear within the Add New Device window:
In such a case, it is possible to re-initiate the Add New Device process by clicking over the
button.
Clicking over the button will terminate the Add New Device process.
Figure 76: Add New Motion Detector Timeout Error Message
11. If the new Motion Detector was properly detected by the CCU within this time-frame, the
counter will freeze and a Device Properties sub-window will appear within the Add New
Device window, where the Motion Detector’s system name/location needs to be typed-in.