User Guide Part 3

Installation of the We.R™ System
92
We.R
System User Guide
Extra holes are punch-outs (covered with thin plastic) that may be removed if
necessary.
3.6.2.2. Installing with Screws
1. Release the Camera wall mounting back cover by lifting the tab and pushing it forward as
illustrated in Figure 40 above.
2. For Flat Wall Mounting:
i. Use a flat screwdriver to remove the punch-outs 1 and 2 (see Figure 41 above).
ii. Place and hold the base on the desired mounting location and mark the drilling
locations (the above-mentioned punch-outs 1 and 2).
iii. Drill the holes; insert two (2) dowels if needed, place the base over them and screw in
the two (2) screws.
Figure 60: Camera Wall-mounting Base with Screws
3
4
5
8
7
6
2
1