User Guide Part 2

Installation of the We.R™ System
We.R
™
System User Guide
33
Registration of the CCU’s serial number (see page 30) should also be completed.
3.2.2.1. CCU Positioning Recommendations
The CCU should be installed on:
 A flat surface.
 In a central home/office location with:
 Unshielded adequate cellular coverage (if cellular communication is to be used).
 Close to an Internet connection outlet (modem/router connection, if Internet
communication is to be used).
The CCU must be activated and the system must be registered with the Service Provider (or
the distributer) to enable its proper operation.
The following need to be executed for the setup and activation of the CCU:
1. Remove the back cover of the CCU to reveal the battery/SIM-card compartment.
2. In case cellular is intended to be used for external communication – insert the SIM-card,
with its contacts facing down, as illustrated in Figure 6 below.
Note: Refer to the graphic representation of the SIM-card engraved onto
the plastic bottom of the cavity, next to the card’s designated location.
Figure 6: Insertion of the SIM-card