User Manual

Operation
56
EverGuard Control Panel
 Password – enter the Password received from the local SIM card provider
 APN – enter the Access Point Name received from the local SIM card
provider
 User Name – enter the User Name received from the local SIM card
provider
4. Click Close. You are returned to the Control Panel screen.
 To configure the Video Scenario Configuration parameters:
The Video Configuration dialog box contains the following tabs:
 Suspect – RF Input device type
 Tamper Alarm – tamper action is detected only from the control panel
 Wrong Code – pin code entered five times incorrectly
 Duress Code – end user enters the duress code
 SOS – end user presses panic button on panel or key fob
 IVD/IPD Security – detects movement via indoor video/photo device
 Comfort – activated by a comfort command message
 Security – activated by a security command message
 Perimeter Alarm – detects movement via outside photo device
 All Units Scenario – activated by a command message
 OPEN/CLOSE – user attendance triggers video/photo upon
arming/disarming
 Configuration – general definitions for video/photo
Note: When the Video Configuration dialog box is initially opened,
all checkboxes are unmarked, and all of the parameters are
disabled. Click a checkbox to enable the parameter.
1. On the Control Panel screen, click Video Scenario Configuration button.
The Video Scenario Configuration dialog box appears displaying the
Suspect tab.