User Manual

Operation
28
EverGuard Control Panel
3.2.9 S.O.S function
In case of emergency, the user should press on the S.O.S button and then the
system will notify the central monitoring station.
When the LED stays permanently red it means that the S.O.S signal has been
received correctly.
A single status LED provides the S.O.S status information. An audible S.O.S beep
is sounded to indicate acknowledgement when an S.O.S message is sent. The
table below details the S.O.S status indicators of the ES7000EG control unit.
Table 12: S.O.S Status Indicators
Sending
Message
Red
Flashing
S.O.S beep
The period between engaging
S.O.S and receiving ACK for
the message
S.O.S State,
After Receiving
ACK
Red
After receiving ACK, for S.O.S
message, before verification
call
No S.O.S
Off
When no S.O.S is
engaged/after verification call
3.2.10 Monitoring Station Status
A single status LED provides the Monitoring Station general status. An audible
“good beep” is sounded when the Monitoring Station button is pressed. The
table below details the Monitoring Station status indicators of the ES7000EG
control panel.
Table 13: Monitoring Station Status Indicators
Call Monitoring
Station Request
Red
After receiving message
requesting to connect the
Monitoring service by pressing
the Monitoring Station
button
Calling Monitoring
Station/No
Monitoring Station
Request Received
Off
Good beep
After pressing Monitoring
Station button/no call request
is sent