User's Manual

Operation
EverGuard Express
15
3.5 Programming the EverGuard Express Panel
A user can program to do the following:
 Define users (PG01)
 Define Entry/Exit Time (PG06,PG07)
 Define Incoming/Outgoing telephone numbers (PG08-PG11)
 Enable/Disable Pin code for arming (PG12)
 Enable/Disable Entry/Exit beeps (PG14)
 Service/Operational mode for Sirens (PG17)
 Return to factory default settings (PG99)
3.5.1 Accessing Programming Mode
The programming mode is accessed by using the programming tool and the
Programming button. The programming tool is located in a holder niche built into
the rear of the EverGuard Express panel and can be accessed by separating the
EverGuard Express front panel and the back component.
If the panel is attached to a wall, push the panel upwards to free it from the wall
mounting. Once the panel is free, locate the latch on the bottom of the back.
Separate the front panel and the back component by inserting a small screwdriver
into the latch and prying gently to open the casing.
Once the components are separated, locate the programming tool and remove it
from the niche. Insert the point into the hole on the front of the panel and push
gently until a confirmation beep sounds.