Instruction Manual

Page 22
500IH-I05-020320
Bakeheart & Warmheart
INSTALLATION INSTRUCTIONS
GENERAL SAFETY INFORMATION
In the UK, the installer has a responsibility under the Health and Safety at Work
Act 1974 to provide for the safety of persons carrying out the installation.
Attention is drawn to the fact that fire cement is caustic and hands must be
washed thoroughly after use. The appliance is heavy and care must be taken
during handling. Although the appliance does not contain asbestos products, it
is possible that asbestos may be disturbed in existing installations and every
precaution must be taken.
These instructions give a guide for the installation of the appliance but in no way
absolve the installer from responsibilities to conform to British Standards, in
particular BS8303 and BS6461, relating to the installation of solid fuel
appliances. All local regulations including those referring to national and
European standards need to be complied with, when installing this appliance.
Outside of the UK, the installer must comply with all local, national & European
standards that apply. Any adjacent combustible material should be far enough
away from the appliance so as not to raise 60ºC above the room temperature
when the appliance is in operation. If necessary, any adjoining walls should be
protected from the effects of heat. Clearances from combustible materials are
400mm from the sides and 500 mm from the rear for the Bakeheart, and 350mm
from the sides and 400mm from the rear for the Warmheart. The Warmheart is
also certified for use on decorative hearths.