Installation Guide

Page 20
ONE-SE-I07-190619
SOLID MINERAL FUEL BURNING
The Esse One-SE comes set up as a Wood Burning only stove as standard. It can be
converted to burn solid mineral fuel with the purchase of the solid mineral fuel burning
kit (Part No: ESSE 1 MF KIT). See instructions below to fit the conversion kit.
1
Ensure that the stove is cold and not lit.
Open the door and remove all the ash, any
unburnt material and the vermiculite
bricks.
2
Insert both solid mineral fuel burning rear
bricks (Part No: FM5-040). There are relief
holes in the back of the bricks to allow the
brick to sit over the bolts in the back of the
stove.
3
Insert a solid mineral fuel bottom side brick
on the Left hand side of the Stove (Part No:
FM5-041).
5
Insert a solid mineral fuel top side brick on
the Left hand side of the Stove (Part No:
FM5-042).