Operation Manual

30 Esscom Twintalker 9210
Esscom Twintalker 9210
12 Battery Charge Level/Low Battery Indication
The BATTERY CHARGE LEVEL is indicated by the number of squares present inside the
BATTERY icon on the LCD Screen.
Battery Full
Battery 2/3 charged
Battery 1/3 charged
Battery empty
When the BATTERY CHARGE LEVEL is low, the BATTERY icon will flash to indicate that
the batteries need to be replaced or recharged.
13 Using the Twintalker 9210
13.1 Stopwatch
Press and hold for 4 seconds to enter stopwatch mode
Press to start counting
Press to stop counting
Press to reset the timer
Press and hold for 4 seconds to exit stopwatch mode
13.2 Turning the Unit ON/OFF
To activate; press and hold . The unit will “beep” and the LCD Screen will display the
current channel, CTCSS code and time.
To switch off; press and hold again. The unit will “beep” and only the time is
displayed.
13.3 Adjusting Speaker Volume
The Speaker Volume can be adjusted using and . The Speaker
Volume level is displayed on the LCD.
13.4 Receiving a Signal
The unit is continuously in the RECEIVE mode when the unit is ON and
not transmitting. When you receive a signal on the current channel, the
RX icon is displayed.
In order for other people to receive your transmission, they must be set
on the same channel and CTCSS code