Owner's Manual

Monitor installation
CAUTION: Make sure the
screws are NOT long enough
to go through the roof!
Route cables using hardware supplied.
Attach the monitor mounting plate
by screwing through the headliner
and into the existing roof supports
or the wood bracket you made
(see
TIP below).
1
1
NOTE
Hardware shown in this illustration
is notprovided due to varying
installation requirements.
Cut hole in headliner for metal plate
to
fit a 11/2 overlap is need for plate
carefully secure plate to headliner or
support beam [not roof].
Align
mounting holes secure unit to
mounting plate tighten all screws evenly
not
to deform housing.
IN$TALLATION TIP
Makefj MQUNTlNGI3RACK/2T OtIt of wood. This braCket mounts un<;ierthe hel3d1iner;
andprcvides a tTJOuntingsur!ace to whichthe housing of the flip--down monitor can
be attached~
Page III