User manual

16 Channel Embedded Digital Video Recorder User Manual 17
finished, the buzzer is off automatically.
(3) Event duration means the duration of alarm when the start of event setup. Press the
arrow key to select [Event Duration], popup dropdown menu with PTZ, and then press the
arrow to choose working time. There are following options:
（3/5/10/20/30/60/120/180/300/600/900/1200 S）, while the system default is 10 seconds.
Finally, press ON/OFF to apply selected time with PTZ.
(4) Setting the above parameters, press the arrow key to Enter and PTZ to save the
parameters.
Picture 4-20
4.7.3 Channel Setup
Click "Main Menu" → "Channel Setup" , the interface is shown as picture 4-21.There are
following options: Channel number, Channel name, PTZ protocol, Baud rate, PTZ address code and
color setup.
1. Channel number: Press the arrow key to select "Channel number", and press PTZ to apply
the selected channel.
2. Channel name: Press the arrow key to select "Channel name" and PTZ to popup the edit
menu( Chinese, English, Numeric, Special character can be input as channel name), if
input numeric or lower case, just use the arrow key to select directly; if input capital letters,
user should press "Caps" of edit menu to switch to capital input; if input special
character, press the ",." of edit menu to switch to special character input; if input Chinese,
press "En" of edit menu to switch to Chinese input. 16 characters are supported.
3. PTZ Protocol: This protocol is used to realize the communication with PTZ. In order to
control PTZ cameras, PTZ should be connected with PTZ port of DVR. Press the arrow
key to select "PTZ Protocol"and PTZ to popup the dropdown menu, with the click of arrow
key to choose appropriate protocol and enter PTZ to apply the selected protocol.
There are a number of protocols could be used: PTZ-NULL, LG LPT-A100L,
DRX-502A(Demo), PELCO D, NK-97CHE, SAMSUNG SCC-641, PELCO P, SJ2819RX,
SAMSUNG MRX-1000, Techwin SPD1600/2500, Wonwoo Eng: SBO-201P1, Panasonic
WV-CS850.
4. Baud Rate: Press the arrow key to select [Baud Rate], popup dropdown menu, and then
press the arrow key to choose appropriate baud rate, at last, enter PTZ to apply the
selected baud rate.