User manual

16 Channel Embedded Digital Video Recorder User Manual 15
Setting method (following introduce use Remote control for demonstrating)
(1) Press the arrow key to select [Sensitivity], popup dropdown menu with PTZ, and then press the
arrow key to choose “Sensitivity”.
(2) Enter PTZ to apply the selected sensitivity.
Picture 4-16
MD Area Setup
MD Area refers to corresponding MD area in motion detection when the event record mode is
motion detection or alarm record.
(1) Press the arrow key to select [MD Area], popup dropdown menu with PTZ, and then press the
arrow to choose some part, and enter the interface with the click of PTZ. (Shown as picture 4-17)
(2) Press the arrow key to select the starting point of motion detection and PTZ to apply the choice,
and move the cursor to choose desired motion area, then enter "ESC" to exit the interface, at
last, press "Enter" to save above settings.
Picture 4-17
3）HDD Error
Click DISPLAY to "HDD ", shown as picture 4-18.
HDD mistake is that when there is mistake of HDD, DVR will alarm to remind the user.
Setting method:
（1） Press the arrow key to select [Alarm Output], enter PTZ to choose action port, and press
"Enter" to exit.
（2） Buzzer setup: To check DVR whether enable beep when set event trigger. Select "Buzzer",