Specifications

31
4
/
8
-
channel Embedded Digital Video Recorder
Channel switch: Each channel has a corresponding switch. Press “Enter” to
select motion detection “On” or “Off”.
Detection sensitivity: Each channel has a corresponding sensitivity setting, with
the 4 levels of 1, 2, 3 and 4, in which 4 is the highest. Press “Enter” for
changeover.
Area setup: Each channel has a corresponding motion detection area setting.
Move the cursor to “Setup” of the corresponding channel, and press “Enter” to
enter the motion area setup screen of this channel, where a red block indicates
motion detection is activated for this area and a transparent block indicates
motion detection is not activated, as shown below:
Operating prompt:
Remote controller operation: Use “
“ (display mode) to select full screen or
blank;
Mouse operation: Left-click the mouse and drag the motion box to set the area of
dynamic detection.
Motion detection setup procedures: