Installation manual

46 Reference & Installation Manual
authority, or electrician, as appropriate.
The Load Number (LN) assigned to each terminal device denotes the
percentage of the total load to be connected to a telephone loop which is
used by the device, to prevent overloading. The termination on a loop may
consist of any combination of devices subject only to the requirement that
the total of the Load Numbers of all of the devices does not exceed 100.
Industry Canada certification is only applicable to installation of devices
which include transformers approved by the Canadian Standards
Association (CSA).
Requirements and Guidelines for UL Installations
UL has only evaluated the 728ULT for compatibility with the Ademco model
685, FBI model CP220FB, SUR-GUARD SG-MLR2-D6 and Silent Knight
model 9000.
UL listed in accordance with standard UL1023 (Household Burglar - Alarm
System Units), standard UL985 (Household Fire Warning Units) and
UL1635 (Digital Alarm Communicator System Units). Look for the UL mark
on the product. Only products bearing this mark are UL listed.
Some operational features are not permitted in UL installations. To respect
the standards for household applications, the installer should follow these
guidelines when configuring the system.
1. All components of the system should be UL listed for the intended
application.
2. If the installation is a FIRE ALARM application, refer to NFPA Standard
74 for details on smoke detector locations. There must be at least one
UL-Listed Indoor Fire Alarm Warning Signalling Appliance.
3. For UL/cUL Burglar Applications:
Maximum entry time = UL 45 seconds/cUL 60 seconds
Maximum exit time = UL 60 seconds/cUL 120 seconds
Minimum bell cutoff time = 5 minutes
4. Keypad Models 639, 642 and 646 are not UL/cUL listed. Do not use the
708 or Esprit with a UL installation--they are not UL listed.
5. The upload/download software should not be used on UL listed systems.
6. All outputs are Class 2 or power-limited, except for the battery terminal.
The Class 2 and power-limited fire alarm circuits shall be installed using
CL3, CL3R, CL3P or substitute cable permitted by the National Electrical
Code, ANSI/NFPA 70.
Label: US: 5A7AL01B728ULT
Filing Type: New Filing
Product Identifier: 728ULT
Equipment Code: AL
Network Address Signal Code: E
Country of Origin: CANADA (CAN)
AC Ringer Equivalent Number: 01B
USOC Jacks: RJ31X
Equipment Description: Control panel for residential burglar and fire
warning systems
Rechargeable Acid/Lead or Gel Cell Backup Battery: 12Vdc, 4Ah/7Ah; UL/
cUL: 12Vdc, 7Ah only
Transformer: Universal, Model No. UB1640W, 16.5Vac (50-60Hz) 20VA
minimum (40VA recommended). Do not connect the transformer to a
switch-controlled outlet.
Bell/Siren: UL/cUL Wheelock 46T-12
Aux Power: 450mA (fuseless shutdown at 650mA); UL: 200mA maximum
for 24Hr stand-by
Smoke Detector: 2-wire Hochicki model SLR 835BH-2 (see page 10 for
more information)
Warning: For UL installations, the metallic enclosure must be grounded to
the cold water pipe or to the grounding rod.
UL/cUL: All outputs are Class 2 or power-limited, except for the battery
terminal. The Class 2 or power-limited fire alarm circuits shall be installed
using CL3, CL3R, CL3P or substitute cable permitted by the National
Electrical Code, ANSI/NFPA 70.
Requirements and Guidelines for AUSTEL Installations
Austel-approved installations: use a transformer approved by the State
Electricity commission, such as "Dyen" PA series 15Vac 22VA. With this
transformer, do not exceed the following maximum currents:
- maximum Auxiliary current (including keypads): 300mA
- maximum Bell current: 600mA
Requirements and Guidelines for cUL Installations
When the system controls a fire alarm system, wiring method must
correspond to section 32 of the Canadian Electrical Code.
Look for the cUL mark on the product. Only products bearing this mark are
cUL listed.738 Ultra is not UL listed.
Rechargeable Acid/Lead or Gel Cell Backup Battery: 12Vdc, 4Ah/7Ah; UL/
cUL: 12Vdc, 7Ah only
Transformer: Universal, Model No. UB1640W, 16.5Vac (50-60Hz) 20VA
minimum (40VA recommended). Do not connect the transformer to a
switch-controlled outlet.
Bell/Siren: UL/cUL Wheelock 46T-12
Aux Power: 450mA (fuseless shutdown at 650mA); UL: 200mA maximum
for 24Hr stand-by
Smoke Detector: 2-wire Hochicki model SLR 835BH-2 (see page 10 for
more information)
© 2003-2005 Paradox Security Systems Ltd. Esprit and Ultra are
trademarks or registered trademarks of Paradox Security Systems Ltd. and
its affiliates in Canada, the United States and other countries. All rights
reserved. Specifications may change without prior notice. One or more of
the following patents may apply: 6215399, 6111256, 5751803, 5721542,
5287111, 5119069, 5077549, 5920259 5886632. Canadian and
international patents may also apply
FCC WARNINGS
IMPORTANT INFORMATION
This equipment complies with Part 68 of the FCC rules. Inside the cover of
this equipment is a label that contains, among other information, the FCC
registration number of this equipment.
NOTIFICATION TO TELEPHONE COMPANY
Upon request, customer shall notify telephone company of particular line to
which the connection will be made, and provide the FCC registration
number and the ringer equivalence of the protective circuit.
GENERAL
This equipment shall not be used on coin telephone lines. Connection to
party line service is subject to state tariffs.
RINGER EQUIVALENCE NUMBER (REN)
The ren is useful to determine the quantity of devices that you may connect
to your telephone line and still have all of those devices ring when your
telephone number is called. In most, but not all areas, sum of the ren's of
all devices connected to one line should not exceed five (5.0). To be certain
of the number of devices that you may connect to your line, you may want
to contact your local telephone company.
EQUIPMENT MAINTENANCE FACILITY
If you experience trouble with this telephone equipment, please contact
facility indicated below for information on obtaining service or repairs. The
telephone company may ask that you disconnect this equipment from
network until problem is corrected or until you are sure that the equipment
is not malfunctioning.
FCC PART 15, WARNINGS INFORMATION TO USER
This equipment has been tested and found to comply with the limits for