Installation manual

Esprit 748+ 37
Part 10: OTHER OPTIONS
10.1 Telephone Line Monitoring (TLM)
Feature Select Programming D Address 086, key [2nd] & [1]
Default: TLM Disabled
When enabled, the system verifies the existence of a telephone line every 4 seconds. After each successful test, the dialer LED
(green light) on the control panel flashes briefly. If the test fails the LED flashes on and off until the control panel detects the
telephone line again. TLM will activate a trouble when less than 3 volts is detected in four consecutive tests.
Note: when the dialer detects a telephone ring, the TLM test stops for 1 minute.
There are three TLM options, which are set as indicated in table 9:
1) OFF/ON: Line test failure will generate a trouble indication; key [10] will illuminate on the keypad.
2) ON/OFF: Line test failure will generate a trouble indication and an alarm if the system is armed.
3) ON/ON: Line test failure will generate a trouble indication and cause a silent zone or a silent panic alarm to switch to audible
mode.
[
ENTER] + Installer Code + [10] [8] [6] + [2nd] & [1] On/Off + [ENTER]
10.2 Dialing Options
Feature Select Programming D Address 086, key [7]
Default: Pulse Dialing
You can program the control panel to use the pulse dialing or tone/DTMF dialing format.
Key [7] "Off": Pulse Dialing
Key [7] "On": Tone/DTMF Dialing
[
ENTER] + Installer Code + [10] [8] [6] + [7] On/Off + [ENTER]
10.3 Dialing Pulse Rates
Feature Select Programming D Address 086, key [10]
This selection reflects the ratio between "pulse" time and "quiet" time. Select Pulse Europe for a 1:2 ratio and select Pulse USA
for 1:1.5. Must be set to pulse dialing mode, refer to section 10.2.
Key [10] "Off": Pulse Europe 1:2
Key [10] "On": Pulse USA 1:1.5
[
ENTER] + Installer Code + [10] [8] [6] + [10] On/Off + [ENTER]
10.4 Keypad Panic Options
Feature Select Programming D Address 088 keys [1] to [6]
This feature will generate an alarm when the User presses two specific keys on the keypad simultaneously for 2 seconds as
described below:
Key [1] "on" = Panic 1 (keys [1] and [3] or PS1) enabled
Key [2] "on" = Panic 2 (keys [4] and [6]) enabled
Key [3] "on" = Panic 3 (keys [7] and [9]) enabled
Keypad panic options:
Table 12 - Telephone Line Monitoring (TLM)
Key
[2
ND][1]
OFF OFF - TLM is disabled (default)
OFF ON - TLM generates a trouble only
ON OFF - generates an alarm if armed
ON ON - silent alarm becomes audible
(address 086, key [9] has to be OFF)