Installation manual

32 Reference & Installation Manual
8.1 Timed Auto Arming
Feature Select Programming D Address 086, key [5]
Default: "Timed" Auto Arming Disabled
The alarm system will automatically arm itself at a specified time everyday. Note, as with regular arming, the system will not arm
if a zone is open and will report a "late to close" to the monitoring. If this occurs, the system will not arm until the next day. The
type of arming is dependent on the Auto Arming Options (see below). Program the Auto Arm Time as described below.
8.1.1 Auto Arm Time
The control panel will automatically arm itself at the specified time if "Timed" Auto Arming (see above) is enabled. The
time is programmed using the 24-hour clock (i.e. 8:00PM = 20:00). There are two methods of programming the "Auto
Arm Time" as described below.
Decimal Programming
D Address 044 & 045
Program the "Auto Arm Time" in hours into address 044 and the "Auto Arm Time" in minutes into address 045.
[ENTER] + Installer Code + [10] [4] [4] + 3-digit decimal value (hours) + [10] [4] [5] + 3-digit decimal value (minutes) +
[
ENTER]
Key Access Programming
D key [9]
The User 1, Master, or Installer can program the "Auto Arm Time" using this method.
[
ENTER] + (Installer, Master, or User 1 Code) + [9] + 2 digits representing hours + 2 digits representing minutes +
[
ENTER]
8.1.2 Auto Arming Options
Feature Select Programming D Address 090, key [2]
Default: Regular Arming
The "Auto Arm" feature will arm the system as described in the table below.
Table 8 - Auto Arming Options
8.2 No Movement Auto Arming
Feature Select Programming D Address 086, key [6]
Default: Disabled
If the control panel does not detect any movement (zone openings) for a specified period, the panel will arm the system and
transmit the event code programmed at address 517. Note the type of arming is dependent on the Auto Arming Options (see
section 8.1.2). Program the "No Movement" Auto Arm Time as described below.
Key [6] "Off": No Movement Auto Arm Disabled
Key [6] "On": No Movement Auto Arm Enabled
[
ENTER] + Installer Code + [10] [8] [6] + [6] On/Off + [ENTER]
8.2.1 No Movement Auto Arm Time
Decimal Programming D Address 055
Default: Disabled
000 = disabled; (001-255) X 15 minutes
If the "No Movement" Auto Arming (see above) feature is disabled and a time is programmed, the control panel will
transmit the event code programmed at address 517 if no movement is detected during the programmed period.
[
ENTER] + Installer Code + [10] [5] [5] + 3-digit decimal value (001-255) + [ENTER]
8.3 One-Key Regular Arming
Feature Select Programming D Address 088, key [7]
Default: Disabled
A User can "Regular" arm the system by pressing and holding the [10] key for 2 seconds.