Installation manual

Esprit 748+ 17

5.9 Automatic Event Buffer Transmission

Feature Select Programming

Address 088, key [2nd]

Default: Automatic Event Buffer Transmission Disabled

When the event buffer reaches 50% capacity, the control panel will make two attempts to establish communication with a PC. The

control panel will call the Computer Telephone Number (see section 5.4) programmed at addresses 008 to 015. The Espload

software must be in "wait for dial tone" mode. When the system establishes communication, it will upload the contents of the

event buffer to the Espload software. If communication is interrupted before transmission of the complete contents of the buffer,

or if after two attempts, communication is not established, the system will wait until the event buffer is full before attempting to re-

communicate with Espload. When the Event Buffer is full, each subsequent new event will erase the oldest event in the buffer.

Key [2nd] "Off": Automatic Event Buffer Transmission Disabled

Key [2nd] "On": Automatic Event Buffer Transmission Enabled

[

ENTER] + Installer Code + [10] [8] [8] + [2nd] On/Off + [ENTER] twice