Installation manual

16 Reference & Installation Manual
5.3 PC Password
Streamline - Section 01 D Hexa Programming - Addresses 006-007
This four-digit download password identifies the PC to the panel, before beginning the download process. Enter the same
password into the Espload software and the control panel. If the passwords are not the same, Espload will not establish
communication. Enter any hexa digits from 0 to F.
[
ENTER] + Installer Code + [10] [10] [6] + First 2 digits + [10] [10] [7] + Final 2 digits + [ENTER]
5.4 Computer Telephone Number
Streamline Section 02 & 03 D Hexa Programming - Address 008-015
The control panel will dial this telephone number when trying to initiate communication with the PC (see section 5.5 Call
Espload). There is no default telephone number and you can enter any number from 0-9 up to a maximum of 16 digits. If you
would like to enter any special keys or functions refer to table 3 in section 6.3. If the telephone number contains less than 16
digits, press the [trbl] key to indicate the end of the telephone number.
[
ENTER] + Installer Code + [7] + [10] [2] + Telephone Number (if <16 digits press [TRBL]) + [ENTER]
5.5 Call Espload
Key Access Programming D key [TRBL]
The control panel will dial the telephone number entered at addresses 008-015 (see section 5.4) in order to communicate with the
Espload software. The control panel and the computer will verify that the Panel Identifier and the PC Password match before
establishing communication (see sections 5.2 and 5.3).
Press [
ENTER] + (Installer, Master, or User 1 Code) + [TRBL]/[TBL]
5.6 Answer Espload
Key Access Programming D key [AWAY]
By entering the code sequence listed below, you can manually force the control panel to answer any incoming calls from the
Espload software. This option can also be used to perform an on-site upload/download by connecting your computer directly to
the control panel using an ADP-1 line adapter and manually answering Espload from the control panel. In Espload go to:
Main Menu - Program Setup - Modem & Printer Configuration
Set "Dialing Condition" to "Blind Dial". Program the panel telephone number in Espload and follow the instructions on the ADP-1
adapter. When the computer has dialed press:
[
ENTER] + (Installer, Master, or User 1 Code) + [AWAY]
5.7 Cancel Communication
Key Access Programming D key [STAY]
Use the Installer Code to cancel all communication and erase any unreported events in the buffer until the next reportable event.
Use the Master or User 1 code to cancel communication attempts with Espload.
[
ENTER] + (Installer, Master & User 1 Code) + [STAY]
5.8 Call Back
Feature Select Programming D Address 086, key [4]
Default: Call Back Disabled
For additional security, when a PC using the Espload software attempts to communicate with the control panel, the control panel
can hang-up and call the PC back in order to re-verify identification codes and re-establish communication. When the control
panel answers the call, it will verify if the Panel ID and PC Passwords match and if they do, the control panel will hang-up and call
the Espload software back. The Espload software will automatically go into "wait for dial tone", ready to answer when the control
panel calls back. Please note the Computer Telephone Number (see section 5.4) must be programmed in order to use the "Call
Back" feature.
Key [4] "Off": Call Back Disabled
Key [4] "On": Call Back Enabled
[
ENTER] + Installer Code + [10] [8] [6] + [4] On/Off + [ENTER] twice