Installation manual

Esprit 748+ 13
Figure 22
4.2.2 Hexa Streamlined Section Programming
This is an alternate method to Hexa Programming. The addresses (000-043 and 300-527) programmed in the Hexa
Programming method are grouped into 67 sections where each section contains four addresses (i.e. section 00 = addresses 000-
003). Using this method allows you to program 8 digits (4 addresses) without having to exit and re-enter addresses. When
entering the final digit, the software will automatically advance to the next section.
Example: If you complete the "Programming Guide" with the desired data, you can program the 68 sections by entering
all digits without pressing [enter] or entering any other addresses. This greatly reduces programming time.
Note: the keypad will not display the current data in the Hexa Streamlined Programming method. To program using the Hexa
Streamlined Section method:
1) Press [
ENTER] + Installer code + [7]
2) The [
ENTER] and [2ND] keys will flash to indicate you are in streamlined programming mode
3) Enter 2-digit section (00-67)
4) The [
ENTER] key will remain on and the [2nd] key will turn off
5) Enter 8-digit data to program the section
6) The keypad will "beep" to indicate that the section has been programmed, data is saved and the software has advanced to the
next section
7) Return to step 4 to continue programming or press [
CLEAR] to exit programming mode
4.2.3 Decimal Programming
Addresses 044 to 061 are programmed using the Decimal Programming method. Values entered must contain three digits from
000 to 255 (where the [10] key = 0). To program using the Decimal Programming method:
1) Press [
ENTER] + Installer Code
2) The [ENTER] key will flash to indicate you are in programming mode
3) Enter 3-digit address (044-061)
4) The keypad will now display the current 3-digit data currently saved at this address as described in Figure 22