User Manual

computer radio control system
EN
5 RF Transmitter Modules
In order to achieve the highest transmission quality and reliability of
the DC/DS-16 transmitter, we have decided to equip the radio with
two independent DUPLEX 2,4GHz transmitter modules. The
transmitter modules have separate antennas. From the point of
transmission they are fully independent from each other. The RF
modules of the transmitter can operate in following modes:
• „Initial“mode – the primary transmitter RF module is active.
The secondary module can act as redundant unit. If the primary
module does not receive feedback from the receiver, the transmitter
can switch to the secondary transmitter RF module and
communicate with the receiver.
• „Dual“mode – the transmitter RF modules communicate
independently from each other with two different receivers. The
receivers can be interconnected via an intelligent synthesizer, for
instance the JETI Enlink, or the basic control functions can be divided
between two independent receivers. In this mode one part of a
model can be controlled with one receiver using the first transmitter
RF module, the other part of a model with a second receiver and the
second RF module. In an instant you have created a dual, redundant
flying system with two receivers and two RF modules.
• „Trainer“mode – the secondary RF transmitter module is
assigned to communicate with the instructor/student transmitter
only. Communication with the model takes place via instructor’s
transmitter only. If the DC/DS-16 transmitter is in the „Instructor“
mode, the primary RF module communicates with the model and
the secondary RF module communicates with the student’s
If you are going to operate the DC/DS-16 transmitter in France,
your transmitter should be setup for French transmitting mode
„Main menu -> System ->Configuration -> French mode -> Yes“
Note:
transmitter. In the „Student“ mode the DC/DS-16 transmitter
communicates via the secondary RF module with the instructor’s
transmitter. If you operate two of the DC/DS-16 transmitters; one of
them in the „Instructor“ mode and the other one in the „Student“
mode, the transmitters communicate between each other via the
secondary RF transmitter module. With this advanced system NO
additional equipment is necessary.
2.2.
21