User's Manual

computer radio control system

4. Disconnect the flat flexible cable from its connector on the

main board.

The flat flexible cables that link the main printed circuit board

with the switches are oriented as shown in the picture (4a).

The wire is always color coded on one side of both ends (4b).

The markings must be oriented as shown below.

4.4.2 Assembly Procedure

1. Insert the flat flexible cable to the switch connector of the

switch. See the orientation above.

2. Push the switch into its spot in the transmitter housing.

3. Tighten the switch installation nut from the front of the

transmitter. Use the specialized wrench (not included).

4. Connect the flat flexible cable to the main printed circuit board

of the transmitter. See the orientation above. The cable has to

be inserted to the connector that matches the position on the front

panel where the switch is installed.

5. Reconnect transmitter battery pack and reinstall radio back

cover and cover screws.

When replacing the switch it is also necessary to Sa

remove the switches and from the transmitter Sb Sc

body.

When replacing the switch it is also necessary to Sc

remove the switch from the transmitter body.Sb

When replacing the switch it is also necessary to Sh

remove the switches and Sf from the transmitter Sg

body.

When replacing the switch it is also necessary to Sf

remove the switch from the transmitter body.Sg

Note:

After you turn on the transmitter for the first time after any switches

have been modified, you will notice that the configuration for a

selected model no longer matches.