User's Manual

computer radio control system

4.3.6 Changing the transmitter mode

The transmitter is equiped with universal multimode gimbals. Both

gimbals are identical and can be adjusted mechanically for modes 1-

5. After mechanical adjustment it is necessary to set a specific

transmitter mode in the menu System – Configuration – Stick mode

1-4.

To change the quad sticks settings, unscrew the back cover of the

transmitter and disconnect the battery connector.

A. Setting the multi-mode gimbal into the mode without

locking the middle position - gas

1. A.Loosen the screw

2. C. Lift the lever B so as it is possible to arrest the lock

3. C Turn the lock 90° in the direction of the arrow and arrest the

lever in the upper position. B

4. A. Tighten the screw

5. D E Tightening the the screws and sets the desired tension with

steps and smooth brake.

1. A.Loosen the screw

2. B. Slightly lift the lever

3. C B Turn the lock in the direction of the arrow and arrest the lever

in the upper position.

4. C Move the lever in the direction of the arrow to release the lever

5. A. Tighten the screw

6. Loosen the screws E and D in a position so that tension is removed

from the stick.

B. Setting the multi-mode gimbal into the mode with locking

the middle position - elevator