User's Manual

computer radio control system

3.8 Handling

The DC-16 II transmitter can be comfortably carried by the antenna

cover/handle as shown in the image below.

Before each flying session, and especially with a new

model, it’s important to perform a range check. If you

are operating a model with a DC-16 II transmitter do

not shield and avoid contact of the transmitter

antenna with your body. This might increase

likelihood of range problem.

Warning:

3.7 PPM Input/Output Connector

The PPM output is accessible via internal connector labeled "B". This

connector features a non-stabilized battery voltage output in the

range of 3.2V - 4.2V (max. 1A) which can be used as a power supply

for the connected HF module as well as for the PPM signal output.

The transmitter output functions are in the form of a standard PPM

signal.

1. PPM input (3V logics)

2. Positive (+) pin

3. Negative (-) pin

4. PPM signal output (3V logics, configurable in „System

->Configuration”)