Users Manual

computer radio control system

Double Path Wireless Mode

a) Mode Selection.

b) Primary module bind control menu line

c) Secondary module bind control menu line

d) Optional signal loss alarm settings.

Trainer Mode with two JETI DS/DC Radios

Make sure that the instructor’s transmitter is bound to the 1.

aircraft in the “Default” wireless mode and that all flying

surfaces are functioning properly.

Change the instructor’s transmitter (DS/DC-14/16/24) wireless 2.

mode to “Teacher” and authorize the secondary TX module to

bind with the student’s transmitter.

Switch ON the student’s transmitter (DS-12), change its wireless 3.

mode to “Student” and allow the instructor’s transmitter to

bind properly. Verify that all of the aircraft’s surfaces are

correctly controlled by the student’s transmitter. If they are not

correct, make the necessary changes in the student’s

transmitter.

Trainer Mode for JETI DS-12 as the Instructor Radio

Other brands of transmitters can be used by the student with a JETI

Duplex EX 2.4GHz radio system by using a PPM cable for

communication with DS-12 transmitter.

1. Make sure that the instructor’s transmitter is bound to the

aircraft in the “Default” wireless mode and that all flying

surfaces are functioning properly.

C h a n g e t h e i n s t r u c t o r ’s t r a n s m i t t e r m o d e t o2.

“Teacher” and connect the PPM signal from the "Student"

transmitter to the DS-12 PPM input (Jack).

Verify that all of the aircraft’s surfaces are correctly controlled by 3.

the student’s transmitter. If they are not correct, make the

necessary changes in the student’s transmitter.

4. 4.