User Manual

Table Of Contents

computer radio control system

4. 4.

1. Ailevator Global or Separate Setting

The Ailevator configuration for both channels can be set collectively

for all flight modes by selecting the “G -Global” symbol or you can

set individual Ailevator settings in each separate flight mode by

sellecting the “S-Separate” symbol.

2. Ailevator Setting

Ailevator configuration has four different adjustable parameters.

The lines marked “Elevator” and “Aileron” contain two columns

“S1” and “S2” which represent the elevator and aileron surface

throws as a percentage. Scroll and highlight the lines marked as

“Elevator” or “Aileron” with the “3D Control” button and press the

“3D Control” button to access the individual setting of each servo. If

the servos need to be adjusted independantly, use the “F1 (Sym.)”

button to unlock the servo travel for adjusting the individual values

in the selected menu line.

9.2.8 V-Tail Mix

If your model is equipped with a V-Tail, The two basic tail functions

(rudder and elevator) are mixed to control the tail of the airplane. The

V-Tail mix has to be activated by choosing the “V-Tail 2H” tail setting.

Unless you have previously chosen a different percentage for one of

the tail mixes, the initial settings for “V-Tail” function are 50% of the

rudder and elevator travels.

1. V-Tail Global or Separate Setting

The V-Tail configuration for both channels can be set collectively for all

flight modes by selecting the “G-Global” symbol or you can set

individual V-Tail settings in each separate flight mode by sellecting the

“S-Separate” symbol.

2. V-Tail Setting

The V-Tail configuration has four different adjustable parameters. The

lines marked “Elevator” and “Rudder” contain two columns “S1” and

“S2” which represent the elevator and aileron surface throws as a

percentage. Scroll and highlight the lines marked as “Elevator” or

“Rudder” with the “3D Control” button and press the “3D Control”

button to access the individual setting of each servo. If the servos need

to be adjusted independently, use the “F1 (Sym.)” button to unlock the

servo travel for adjusting the individual values in the selected menu line.