User Manual

Table Of Contents

computer radio control system

4.6.2 Battery Replacement

Should you decide to replace the transmitter battery, please follow

these steps:

1. Switch off the transmitter and remove the 8 screws that

secure the radio back cover. Next, remove the radio back cover.

2. Disconnect the transmitter battery connector.

3. Loosen the battery fastening strap and remove the battery.

DS-24 transmitters should only be operated only

with original or manufacturer approved battery

packs. The use of other battery packs will void the

warranty.

Warning:

If the transmitter battery has been disconnected for

longer than 1 minute, the time and date will be deleted.

Note:

2.2.

4.7 PPM Input/Output Connector

The PPM output is accessible via connector labeled "B“. This

connector features the non-stabilized battery voltage output in the

range of 3.2V - 4.2V (max. 1A) which can be used as power supply for

the connected HF module as well as for the PPM signal output. The

transmitter output functions are in the form of a standard PPM

signal.

1. PPM input (3V logics)

2. Positive (+) pin

3. Negative (-) pin

4. PPM signal output (3V logics, configurable in

„System->Configuration”)