User Manual

computer radio control system
EN
4. 4.
• Sa – Sl Physical configurable and replaceable switches.
1)
L1 – L24 Logical switches.
2)
•
MAX Logical maximum, can be configured as a switch •
that is always in an on-state.
GX, GY, GZ Individual, independent axis of the built-in •
accelerometers (not available for DC).
2)
G/L, G/R Virtual controls switched on at the moment the •
transmitter is shifted to the left, or respectively to
the right (not available for DC).
2)
• GHi detects large amounts of movement - fast
acceleration and rotation. Useful for the F3K launch
detection (not available for DC).
• GXL, GXR Virtual controls switched on at the transmitter tilt
to the left, or resp. to the right
(not available for DC).
2)
Q1 – Q10 Individual sequencers.
2)
•
Tr1 – Tr6 Digital trims as individual controls.•
CH1 – CH8 Channel inputs of the PPM signal lead that is •
attached to the internal connector.
• MX1 – MX16 Telemetry control inputs.
2)
1)
Configuration of the switches depends on the type of transmitter and also on which
switches they are installed.
2)
Controls are available depending on the equipment of the transmitter.
6. PPM input
The transmitter can handle up to 8 channels of the PPM input signal
(please refer to the chapter 3.7 PPM Input/Output Connector). The
signal should be present on the pin No. 1. To prevent any damage,
you need to use the 3V logic level and protective elements on the
input.Throughout the model settings you can assign any of the PPM
channels to any function of the transmitter. The PPM input is not
linked with the trainer system in any way and works separately. It is
possible to use the PPM input in cooperation with head-tracking
systems etc.
7. Apps
The User Applications can offer several outputs (proportional or
two-state). In this dialogue you are able to select the application
output and control some specific model functions.
142