User Manual

4. 4.


computer radio control system
EN


6. Distance units
This menu item allows you to select the distance units for y our
telemetry
displa y . All telemetry data is automatically converted to
6
1
your selected units f or displa y .
2
7. T empera tur e units
T his menu item allo w you to select whether your temperature data is
displayed
in Farenheit or C elcius .
5
8. F r ench T x Mode

A c tivat e this menu item if your DC/DS-16 is being used in F ranc e .
9. Disable Startup Question
This menu item disables the question/confirmation during star tup .
(see Chapter 6)
10. Reverse
Menu na viga tion
This menu item allows you to reverse the direction that the „3D
control“ scrolls through the menus .


9.5.2 Servo & R ange T est
T his menu allo ws you to perform a range test and servo t ests .
During the servo test it is possible to send the test output to all of the
channels which are active in the current model setup . T he ser v o
speed item allows you to adjust the travel time for the servos during
the servo test. During the test, the servos will only be driven to their
programmed maximum thro ws . Y ou can select which servos will be
included in the t est.
3 4

1. Servo speed
This menu item allows you to adjust the servo travel speed for the
servo t est.
T he time shown is the time that it will take f or the servo to move fr om
one travel extreme to the other .
Note:
A servo will only move to it ’ s programmed maximum thro w .
2. Servo Number
Use the “3D C on tr ol” to select which servos will be included (check
mark) or not included ( X) in the servo t est.
3. Starting the Servo
T est
Press the
“F3 (Start)” button to start the test for your selected ser v o
outputs .
Once star t ed , the servo test will continue to run even if you exit the
menu .
Y ou must stop the servo test before you can change any of the t est
settings (speed , output channel).