User Manual

computer radio control system
EN
4.3 Control Stick Assembly
When handling with back cover removed always
switch-off the transmitter and disconnect the
battery (unplug the connector). Also do not connect
the charging adapter or the USB cable.
Note:
Restrict your contact with the printed circuit
boards to a minimum. You can damage your
radio by electrostatic discharge!
Warning:
4.3.1. Control Stick Length Adjustment
The stick length is adjustable to suit your flying style. The stick end
separates into two parts.
1. Hold the top part of the
st ic k e n d f ir ml y an d
u n s c r e w ( t u r n i t
anticlockwise).
2. Turn the stick end
clockwise to shorten or
c o u n t e r c l o c k w i s e t o
lengthen the overall stick
length.
3. Adjust the lower part
to support the top part of
the stick end.
4. Fin al l y s e c u re b y
tightening both parts to
each other.
1
2
3
4
If you have installed optional sticks with switch or
button ends; make sure that while adjusting the
stick length you observe the wires that pass through
the stick shaft and through the gimbal opening in
order to prevent damaging the connecting cables.
The safest method is to de-solder the stick end
switch control wires and remove them from the
gimbal opening during adjustment. (See 4.3.6)
Warning:
4.3.2. Swivel Control Stick Adjustment
In order to customize the feel of your radio you may adjust the angle
of the stick control assemblies.
1. Switch-off the transmitter and remove the 10 screws that
secure the radio back cover. Next, remove the radio back cover.
Be sure to disconnect the transmitter battery pack connector.
2.2.