User Manual



EN
computer radio control system


9.4.2 Alarms
If you use the Jeti telemetry system, in this menu you can set y our
alarm thresholds and choose which sound is played in the alarm
condition. T he transmitter support both first generation Duplex and
Duplex EX alarms .













F irst Generation Alarms
First generation Duplex (non-EX) sensors generate their alarms as
Morse C ode . If you are using first generation Duplex sensors then
you must select „Enable Morse Code Alarms“ using the „3D
button“ . When this option is selec t ed , a table appears . I n this table ,
the first column shows the Morse Code alphabet. T he sec ond
column shows the .wav sound files associated with each lett er . Use
the „3D Button“ to change the .wav file association as needed . T he
third column shows whether the selected .wav file for each letter is
enabled . Use the „3D button“ to enable or disable the alarm sound
as needed . This configuration must be set for each model and is
saved
f or each model independantly .
EX Alarms
Duplex
EX sensors generat e their alarms directly to the transmitt er .
T he corresponding Duplex EX sensor must first be connected to a
Duplex EX receiver and the receiver must be bound to the
transmitt er . I t may take several minutes f or the transmitter to initially
communicate the sensors . T he list of connected sensors is found in:
„Main Men u >Timers/Sensors >Sensors/Logging S etup “ .
For this operation, both the transmitter and all receivers and sensors
must be c onnec t ed and po w er ed .










1. Cr ea ting an Alarm
Use the „F2(Add)“ button to add an alarm. T hen, in the „Sensor“
item, select the sensor whose alarm limit you want to set.
