User Manual

computer radio control system EN
4. 4.




defined (completely off ) throttle position once the assigned swit ch
is activat ed .
5.
T hr ottle Idle S etting
This feature is used to set the idle position for your throttle and will
prevent your engine from shutting-off when you moving
throttle
stick to its low position. T he minimum throttle setting is defined b y
editing the “Idle Offset” value . When this function has been
activat ed , the minimum throttle setting (idle point) is defined by the
offset value as a per c entage . Standard throttle function is not
affected by the idle offset setting .

9.3.2 Sticks / Switches S etup
This menu contains System Stick/Switch settings and c onfiguration.
V arious functions can be activated by any Switch, Stick or K nob
position. Switch setting enables you to set the points when y our
desired function/timer/telemetry can be turned ON or OFF .




1
2. Switch ON/OFF P oin ts
Any proportional function can be set as a system switch. This menu
item enables you to assign the travel percentage at which a desir ed
function can be turn ON or OFF .
“Switch-ON” –
T he point when the control element positon will
switch a function ON.
“Switch-OFF” – T he point when the control element positon will
switch a function
OFF .
By default, the system setting f or all proportional channels and f or all
inputs is set to function the same as a 3-position switch.
a) A function above this point is considered to be “S witch ON”
b)
A function in this range (middle) can be considered to be either
“S witch ON” or “S witch OFF”
c)
A Function below this point is considered to be“Switch OFF”
If the switch setting is set at same level for “Switch ON” and “S witch
OFF” the proportional channel/func tion output will be the same as a
2-position switch.
3. Required Preflight
P osition
For any functions assigned to the Switch, K nob or Stick ; any pr eflight

3


1. Switch & Stick T ype
2
initial position can be pr og rammed . If the pre-programed S wit ches ,
K nobs or Sticks are not in required preflight position while model is
4
being activat ed , system will refuse to switch to this model . T he
transmitter screen will display the function that is not in pr e -
pr og rammed , correct preflight position.
T he first menu line item lists the c ontr ol ’ s number and the sec ond
item lists the type of control element. Using the “F2” and “F3”
function
buttons you can scr oll through channels , with the “F5 (Ok)”
butt on you can exit the menu scr een.
4. Function Status
Displa y
Position and status of the control is displayed in the status bar . On
the right side of this menu you can see status of the switch func tion